Shafts

KIT-WHEEL D/SHAFT PTO HORSE - SERIAL #940750 AND LATERGenuine Troy-Bilt part. Includes both bearing cups and cones. Shaft is 14" in length.Contact Custom Parts at info@custompartsinc.com to verify if you have any questions. Replaces Troy-Bilt part numbers:11601GW-11601

OEM by MTD - Main drive shaft - Horse I and II tillers - welded single piece, includes front and rear drive shaft bearings and races (CP1714) PART ONLY SHIPS VIA UPS AND INCLUDES INSURANCE. Replaces Troy-Bilt part numbers: 1902,GW-1902, 1024, GW-1268, GW-1268A, GW-1550 ...

Discontinued March 2021Main Transmission Drive Shaft Kit - Horse III and PTO ModelsReplaces Troy-Bilt part numbers: 1985GW-1985 

Tapered tine shaft - Fits older Troy-Bilt Horse tillers. Key NOT included.This part is made in the USA. Other Parts that go with the Tine Shaft:  If you have the original 2675 gear you will need the CP1104 Key (.25 X 1.12). If you have the replacement 2675 gear you will need CP97067 Key (.25 X 1.0).CP2675 replacement Bronze worm gear - 30 tooth, 1.25" diameter - fits Horse Model tillers with (CP1026A) tapered tine shaft. Comes with two shims (94017) for correct gear...

Tiller Shaft with 1104 key (used with 20776 tine drive gear) 8 1/2 inches long, 1 inch across. Fits Models:Pony V (5040, 5041, 5050, & 5051)Pony VI (5411 & 5511)Junior III (5211 & 5311)Junior IV (5611 & 5711)Econo Horse (6311, 6411 & 6511)

TINE SHAFT WITH 1104 KEYFITS JUNIOR VI & V AND SOME PONY AND ECONO HORSE MODELS. CHECK YOUR MANUAL.Replaces Troy-Bilt part numbers: 20896, GW-20896, 711-04080

Wheel Shaft - Troy-Bilt "Horse" tillers - 15 5/8" longIncludes: (2) CP9511 retaining rings and (1) CP9357 keyThis part is made in the USA. Replaces Troy-Bilt part numbers:1878GW-18781235A1235911-04025