MTD

SPRING FWD/REV, " HORSE III" AND LATER TILLERS SER# 640000 +NEW STYLE SPRING REPLACES PART NUMBERS: GW-2163 2163 1908156

BLOCK - Belt adjustment, 2 3/4" long, for two-speed tillers, Serial # 314150 and below. Has cast-in Neutral position. Replaces 3/4" steel bar (completely flat) used on previous tillers. Replaces Troy-Bilt part numbers: 11331133-1AGW-1133-1A

PULLEY - ENGINE - HORSE 3/4" BORE.Pulley - Engine - Horse TillersReplaces Troy-Bilt part numbers:1483GW-1483619-04124

KIT-ADJ BLOCK - 4 SPD-HORSEAdjustment Block Kit - All 4-Speed Horse II and Later Model Tillers (Serial numbers 314151 and higher)3 7/8" long -  Includes: (1) 1920 - adjustment block - 3 78" long(1) 9710 - Hex head bolt - 3/8"-16 x 1"(1) 9903 - flat washer - 3/8"(1) 9913 - lock washer - 3/8"(1) 2100 - adjustment toolReplaces Troy-Bilt part numbers:1920GW-1920

KIT-TILLER DRIVE SHAFT - HORSE OPC AND SOME PTO MODELSReplaces Troy-Bilt part numbers: 11602GW-11602

Spring .845x1.25 - Eccentric Shaft - Horse Tillers Serial No. 493014 & Up.  

Screw- Hex, Flange - Handlebar Height Adjustment - Various Pony, Junior and Econo-Horse model tillers. This is a flange screw, not the bolt with the curved handle attached. The original 20703 part has been discontinued and replaced with the screw. Replaces Troy-Bilt part numbers:20703, 1186347,90046,710-04042

Bar - Belt Adjustment Tool - All Troy-Bilt Horse II and later model Horse tillersReplaces Troy-Bilt part numbers:2100GW-2100

PLATE - HANDLE BAR ADJUST Used on various Pony, Junior and Econo Horse Models. Check your model & serial numbers. REPLACES PART NUMBERS: 20753, 1900475010

NUT-HEX LOCK 5/16-18

CLUTCH-DOG - PTO HORSE - TILLER TRANSMISSION Replaces 1909138, 2120-1 and 718-04614

NUT-HEX CENTER L-1 Replaces Part Numbers: 110152, 912-0239, & 712-0239Fits Hydro Garden Tractor Models: 13060, 13062, 13074, 13076, 13101, 1668R, & 5118HR